Nut Welding Machine with nut management,
Nut Detection system
1) Ability to sense fastener presence
and orientation at point of weld.
2) Nut projection height.
3) No nut, eccentricity due to fallen nut or welding defect caused by
application of non-electricity and it stops welding operation to prevent
welding defect and after it discriminates whether is normal and
indicates the result to operator.
4) Detecting defective nut and in case of NOGO it stops welding.
5) Indicating and adjusting the tolerance range of Ok in digital.
6) Allowing welding by one cycle when several nuts are welded in one
work.
7) It detects welding defects after welding.
8) Tip dressing value will be settable.
9) Tip dressing value will be reset by dressing file which will be
located near to machine (optional).
10) The Nut Schedule is available on request.
11) KGF pin up down by air on of switch.
12) Input pressure switch to check all input air.
13) Air regulator, pressure switch, air valve to detect nut position
14) Thermostat for over heat protection of transformer and thyristor
15) Water flow switch to check flow of water
